Printing Does Not Start; Turn The Printer On - Canon iX7000 Series On-Screen Manual

Printing Does Not Start

>
Advanced Guide Troubleshooting
Printing Does Not Start
Check 1: Make sure that the power plug is securely plugged in, then

turn the printer on.

While the Power lamp is flashing green, the printer is initializing. Wait until the Power lamp stops
flashing and remains lit green.
Note
When printing large data such as a photo or graphics, it may take longer to start printing. While
the Power lamp is flashing green, the computer is processing data and sending it to the
printer. Wait until printing starts.
Check 2: Check the status of ink tanks. Replace the ink tank if ink has
run out.
Check 3: Open the Top Cover and check to see if the ink lamps are
flashing red.
If there is still sufficient ink but its ink lamp is flashing red, an ink tank may not be installed in a right
position.
Routine Maintenance
Check 4: Open the Top Cover and make sure that the ink lamps light up
red.
If the ink lamp is not lit, press the
Check 5: If the printer is turned off for some time, it may take longer to
start printing.
Wait until printing starts.
When the printer vibrates after the printer is turned on, it is shaking the ink tanks. Wait until the
printer stops vibrating.
The Printer Is Vibrating/The Printer Makes the Operation Noise Even When the Printer Is Not in
Use
Check 6: Make sure that the printer is connected to your computer
properly.
When the printer is connected to your computer with a USB cable, make sure that the USB cable is
securely plugged in to the printer and the computer, then check the followings:
If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to
the computer, and try printing again. If printing starts normally, there is a problem with the relay
device. Consult the reseller of the relay device for details.
There could also be a problem with the USB cable. Replace the USB cable and try printing
again.
When you use the printer over LAN, make sure that the printer is connected to the network with a
LAN cable or is set up correctly. For details, refer to your setup manual.
Check 7: Restart your computer.
If there are any unnecessary print jobs, delete them.
> Printing Does Not Start
mark on the ink tank until it clicks into place.
Page 376 of 468 pages