Mounting Plate Installation And Setup; Unpacking And Assembly; Enclosure Disassembly - Rice Lake LaserLight Installation & Operation Manual

2.0

Mounting Plate Installation and Setup

The LaserLight remote display can be easily set up and configured once mounted to a wall or pole. This section
describes basic installation, AC wiring, RS-232, RS-485, and 20 mA current loop connections. Once installation
setup is complete, go to Section 3.0 for information on configuring the remote display.
Caution
Use a wrist strap to ground yourself and protect components from electrostatic discharge (ESD) when working inside the
enclosure.
This unit uses double pole/neutral fusing which could create an electric shock hazard. Procedures requiring work inside the
remote display must be performed by qualified service personnel only.
W arning
LaserLight
The has no on/off switch. before opening the unit, ensure the power cord is disconnected from the power outlet.
2.1

Unpacking and Assembly

Immediately after unpacking, visually inspect the
damaged in shipment, notify Rice Lake Weighing Systems and the shipper immediately. The shipping carton
contains the remote display and this manual. The main components of the
• Painted steel enclosure
• Primary and secondary display boards
• Power supply
• Mounting panel for the CPU board (located on back of mounting plate)
Figure 2-1. Mounting Plate Showing Primary / Secondary Display Boards (7-Segment Display)
2.2

Enclosure Disassembly

For ease of installation, remove the mounting plate (which includes the primary and secondary display boards)
before installing the LaserLight
enclosure lighter for installation. Use the following steps to remove the mounting plate from the enclosure.
Use caution when lowering or raising the mounting plate to ensure the LEDs do not touch the enclosure. If
Caution
any of the LEDs get bent, they can be straightened back into position.
1. Remove the captive screws located on the bottom of the enclosure. The mounting plate is located on the
inside of the enclosure. It is mounted on a frame that can be held in place by tabs and two pins, (located
on the inside of the enclosure, shown in Figure 2-2).
2. Glide the mounting plate frame downward so that it hangs freely beneath the enclosure.
3. Disconnect the chassis ground wire from the top of the mounting plate mounting frame.
LaserLight
Primary display Secondary display
remote display. This protects the LEDs from unnecessary jarring and makes the
remote display for damage. If any parts were
LaserLight remote display include:
Mounting Plate Installation and Setup 3