Display Message Command Format (Matrix Display) - Rice Lake LaserLight Installation & Operation Manual

Example Commands and Responses:
Get time and date:
|00GT!
Get the number of 5x7 matrix boards (so, nboards x 4 = ncharacters in display):
|00GB!
Response: "OK" - success (States: DOH = DO1 = +5V) or "??" = error
Get the version number: example return "2.05"
|00GV!
Set the temperature adjustment
|00TP#!
Where # is -5 to +5 (example |00TP-1!, |00TP+3!, |00TP5) default is 0
Dump the configuration parameters (test purposes only):
|00GDC!
3.7.2

Display Message Command Format (Matrix Display):

|<AA><DM>|<Timeout>|<Flash>|<Slide On>|<Scroll>|<Scroll Count>|<Data>!
where:
| = Pipe character (0x7C)
AA = Two byte address, ASCII digits
DM = Two byte command, ASCII characters
<Display Timeout> = Milliseconds to display the message (N/A for scroll). 32.767 (32 seconds) is the maximum
timeout. Anything above that number indicates an indefinite display.
<Flash> = "Y" or "N"
<Slide On> = "Y" or "N"
<Scroll> = "Y" or "N"
<Scroll Count> = Number of times to scroll the message or "A" for annunciator msg cmd (learn enable = OFF)
<Data> = Text to display
! = Exclamation point character (0 x 21)
Command
DM <Data> is the 6 character message to display. If less than 6 characters, send spaces so it
equates to 6 characters. Otherwise, some data may not be overwritten.
Example: |00DMSTOP !
GT Get time and date. Information gathered is sent back to the indicator so that both the remote
display and indicator match. This is not displayed on the remote display.
Example: |00GT!
ST Set time and date. Note that two spaces are required between time and date entries.
Example: |ST08:00:00 2003-01-31!
DI Get digital input state
DO Get digital output state
GR Get relay state. Relay 0-3, 0=Off=LL, state 1=LH, state 2=HL, state 3=On=HH.
SR Set relay state (output relays only). Relay 0-1, state 1=On & 0=Off.
22 LaserLight Remote Display Installation & Operation Manual
Description