Hard disk drives / solid state drives
7.3.2
Installing 3.5-inch HDD modules
Customer Replaceable Unit
(CRU)
Tools: tool-less
7.3.2.1
Preliminary steps
Ê Locate the correct drive bay as described in section
configurations" on page
7.3.2.2
Removing a 3.5-inch HDD dummy module
Figure 75: Removing a 3.5-inch dummy module
Ê Press both tabs together (1) and pull the dummy module out of its bay (2).
V
CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply with
applicable EMC regulations and satisfy cooling requirements.
140
139.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"3.5-inch HDD
RX100 S8