Fujitsu PRIMERGY RX100 S8 Upgrade And Maintenance Manual page 128

Hard disk drives / solid state drives
Figure 60: Connecting the cables to the ODD and the 4 x 2.5-inch HDD backplane
Ê If applicable, push the ODD in its bay until the ODD latch engages (see
orange arrow).
Ê Connect the following cables to the ODD and the HDD backplane:
– (1) SATA cable to ODD (if applicable)
– (2) power cable to ODD (if applicable)
– (3) SAS cable to connector "X5" on the HDD backplane
– (4) power cable to connector "PWR" on the HDD backplane
I
If applicable, connect the OOB cable to connector "SMBus" on the
HDD backplane.
For the cable plan see section
128
"Cabling" on page
Upgrade and Maintenance Manual
272.
RX100 S8