Ppm; Processor - HP DL380 Generation 4 Maintenance And Service Manual

PPM

To remove the component:
Power down the server (on page 20).
1.
Extend or remove the server from the rack
2.
the server from the
Remove the access panel
3.
NOTE: The appearance of compatible PPMs may vary.
Remove the PPM.
4.
IMPORTANT: PPM slots must be populated when processors are installed. If PPM slots are not populated,
the server halts during POST or does not boot.
To replace the component, reverse the removal procedure.

Processor

To remove the component:
Power down the server (on page 20).
1.
Extend or remove the server from the rack
2.
the server from the
Remove the access panel
3.
If an optional redundant fan is located next to the processor, remove the fan
4.
49).
("Extend the server from the
rack" on page 20).
("Access panel" on page 22).
("Extend the server from the
rack" on page 20).
("Access panel" on page 22).
rack" on page 19,
rack" on page 19,
("Hot-plug
Removal and replacement procedures 39
"Remove
"Remove
fan" on page