Close the heatsink locking levers
8.
Connect the heatsink fan cable to the system board
9.
Install the access panel
10.
Do one of the following:
11.
Close or install the tower bezel, as needed.
•
Slide the server back into the rack.
•
Power up the server.
12.
PPM
NOTE: PPM 1 is embedded into the system board.
To remove the component:
Power down the server (on page 26).
1.
Do one of the following:
2.
Unlock and remove the bezel
•
Extend the server from the rack (on page 26).
•
Remove the access panel
3.
Open the PPM latches.
4.
("Access
panel" on page 29).
("Front
bezel" on page 27).
("Access
panel" on page 29).
("System board
components" on page 64).
Removal and replacement procedures 46