Removing A Ppm - HP ProLiant DL580 Maintenance And Service Manual

8. Close and lock the processor retaining bracket.
9. Close the cover, and replace the processor module.

Removing a PPM

The server PPMs provide the proper power to each processor. Each PPM must be
installed in the correct slot for the processor.
To remove a PPM:
1. Power down the server ("Powering down the server" on page 18).
2. Remove the processor module ("Removing the processor module" on page
24).
IMPORTANT: Processor socket 1 and PPM slot 1 must be
populated at all times or the server will not function properly.
IMPORTANT: Always install a PPM when you install a processor.
The system fails to boot if the PPM is missing.
Removal and replacement procedures 29