Hot-Plug Fan - HP DL380 Generation 4 Maintenance And Service Manual

WARNING: To reduce the risk of personal injury from hot surfaces, allow the power
supply or power supply blank to cool before touching it.
To replace the blank, slide the blank into the bay until it locks into place.

Hot-plug fan

WARNING: To reduce the risk of electric shock, personal injury, and damage to the
equipment:
•
Do not attempt to service any parts of the equipment other than those specified in the
following procedure. Any other activities may require that you shut down the server
and remove the power cord.
•
Installation and maintenance of this product must be performed by individuals who
are knowledgeable about the procedures, precautions and hazards associated with
the product.
You must observe the following requirements when installing redundant hot-plug fans:
•
To ensure optimum cooling, populate the primary fan locations, 2, 4, 5, 6, and 7, before populating
the redundant locations
•
If a primary fan fails, replace the non-functioning fan before installing fans in redundant locations
("Identifying hot-plug
To remove the component:
Extend or remove the server from the rack
1.
the server from the
Remove the access panel
2.
If the server is operating with less than seven functional fans, power down the server (on page 20),
3.
then continue with the next step.
("Identifying hot-plug
fans" on page 90).
("Extend the server from the
rack" on page 20).
("Access panel" on page 22).
fans" on page 90).
Removal and replacement procedures 49
rack" on page 19, "Remove