Removing A Ppm - HP ProLiant BL20p Maintenance And Service Manual

Removal and Replacement Procedures
4. Install the heatsink, and close the locking levers.
To remove a PPM:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blade Preparation" section in this chapter.
2. Remove the access panel. Refer to the "Access Panel" section in this chapter.
3. Open the latches on the sides of the PPM slot (1).
4. Remove the PPM from the slot (2).
Figure 2-10: Removing a PPM
Reverse steps 1 through 4 to replace the PPM.
2-12
HP CONFIDENTIAL Codename: Part Number: 316078-001 Last Saved On: 4/3/03 1:22 PM
CAUTION: After the cover is removed, do not touch the thermal interface media. Touching
the thermal interface media could cause processor overheating.
CAUTION: The heatsink is not reusable and must be discarded if removed from the
processor after application.
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide