Power Supply Blank - HP DL380 Generation 4 Maintenance And Service Manual

Remove the hot-plug power supply.
3.
To replace the component:
WARNING: To reduce the risk of electric shock or damage to the equipment, do not
connect the power cord to the power supply until the power supply is installed.
Slide the hot-plug power supply into the power supply bay.
1.
Connect the power cord to the power supply.
2.
Install the cable management arm, if removed.
3.
Route the power cord through the cable management arm or power cord anchor.
4.
NOTE: If using the power cord anchor, be sure to leave enough slack in the power cord so that the
redundant power supply can be removed without disconnecting the power cord from the primary power
supply.
Close the cable management arm.
5.
Connect the power cord to the power source.
6.
Be sure that the power supply LED is green
7.
Be sure that the front panel external health LED is green
8.
76).

Power supply blank

To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
Do one of the following:
1.
•
If the cable management arm is hinged on the left side, proceed by opening the cable
management arm
•
If the cable management arm is hinged on the right side, proceed by removing the cable
management arm
Remove the power supply blank.
2.
("Rear panel LEDs and
("Cable management arm with left-hand
("Non-hot-plug procedures" on page 22).
("Access the product rear
buttons" on page 78).
("Front panel LEDs and
swing" on page 21).
Removal and replacement procedures 48
panel" on page 21)
buttons" on page