Ppm Problems - HP ML110 G2 User Manual

Be sure a memory count error
3.
message displaying memory count during POST.
Memory count error exists
Possible Cause: The memory modules are not installed correctly.
Action:
Be sure the memory modules are supported by the server. Refer to the server documentation.
1.
Be sure the memory modules have been installed correctly in the right configuration. Refer to the
2.
server documentation.
Be sure the memory modules are properly seated.
3.
Be sure no operating system errors are indicated.
4.
Restart the server and check to see if the error message is still displayed.
5.
Run Insight Diagnostics
6.
indicated.
Server fails to recognize existing memory
Action:
Reseat the memory.
1.
Be sure the memory is configured properly. Refer to the server documentation.
2.
Be sure a memory count error
3.
message displaying memory count during POST.
Server fails to recognize new memory
Action:
Be sure the memory is the correct type for the server and is installed according to the server
1.
requirements. Refer to the server documentation or HP website (http://www.hp.com).
Be sure you have not exceeded the memory limits of the server or operating system. Refer to the
2.
server documentation.
Be sure the memory is properly seated.
3.
Be sure no conflicts are occurring with existing memory. Run the server setup utility.
4.
Test the memory by installing the memory into a known working server. Be sure the memory meets
5.
the requirements of the new server on which you are testing the memory.
Replace the memory. Refer to the server documentation.
6.

PPM problems

Action: If the PPMs are not integrated on the system board:
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating
the server in this manner results in improper airflow and improper cooling that can lead to thermal damage.
If applicable, check the PPM LEDs to identify if a PPM failure occurred. For information on LEDs, refer
1.
to the server documentation.
Reseat each PPM, and then restart the server.
2.
If reseating the PPMs is not effective, remove all but one PPM, restart the server to see if the PPM is
3.
working, and then install each PPM individually, cycling power each time. Follow the warnings and
cautionary information in the server documentation.
("Memory count error
("HP Insight Diagnostics" on page 32) and replace failed components as
("Memory count error
exists" on page 63) did not occur. Refer to the
exists" on page 63) did not occur. Refer to the
Troubleshooting 63