Updating Preset Files; Updating Smartcards - Yellowtec Digital Voice Processor Manual

10.5 Updating Preset Files

When loading preset data from the previous
version into VIPremote 4.0 a warning window
appears (see on the right).
Click OK.
The existing presets are assigned to numbers 1-
50. Another 50 presets with default names and
values are appended with numbers 51-100.
Preset files in the *.VIP format are automatically converted to the 4.0 format when
SAVE TO PC are performed.
Note: Internal Preset data without error detection checkworks stored in a VIPdigital unit with firmware
version 4.0 are detected as faulty data. VIPdigital substitutes all preset data with default values (Audio
Processing modules off or neutral values) and the display shows BYPASS.
This can only happen, if the items 1.-5. of the updating procedure
previous section) has been left out.

10.6 Updating SmartCards

Note 1: Saving data to or loading data from SmartCard can be disabled in the configuration of your
VIPdigital. Make sure, that these options are not selected in your VIPdigital configuration.
Note 2: Inserting a SmartCard with preset data from the previous version are detected as non-valid data
and cause an error message on the VIPdigital display: WRONG CARD or FAULTY CARD.
After an update to version 4.0 VIPdigital does not accept SmartCards from the previous version, but
you can load them into VIPremote and convert them to the new format.
Converting procedure
1. Connect your VIPdigital to your PC
2. Start VIPremote
3. Insert your SmartCard into your VIPdigital
4. Click on LOAD FROM
5. After the SmartCard data have been loaded, a warning window appears. Click on
6. Click on SAVE TO SMARTCARD. SmartCard data are converted automatically, provided with
error detection checkworks and saved back to the SmartCard.
Note 3: You cannot use a SmartCard with preset data in the 4.0 format in VIPdigital with a former
firmware version.
VIPdigital Manual 4.0 Yellowtec 2004 Rev. 26.07.2004
VIP. Internal Preset data and SmartCard data are loaded into VIPremote.
SAVE TO VIP
(Performing the firmware
OK
Page 65
or
Update,