Module: Delay - Yellowtec Digital Voice Processor Manual

8.2.10 Module: Delay

The Delay module inserts an adjustable signal delay
into the signal path. As opposed to numerous digital
effect processors, the delay is not used for a "sound"
processing, but exclusively as a technically oriented
tool for a compensation of delay times – such as for
picture-related audio post-processing for a
synchronization to the picture. In particular, the
module cannot be used for echo effects and the
like. Instead, use the Reverb Module for handling
effects of the signal.
The setting range for the delay time is 0 to100 ms.
Please note that VIPdigital inserts an additional transit time for digital signal processing into the signal
path as other digital signal processors do. However, this is extremely low for this processor, using
approximately 1.5 ms. This transit time which always exists independently of the Delay module must
be added to the delay time set in the Delay module if the entire signal transit time is to be determined.
The position of the Delay module (i.e. in front of the Reverb module) is not variable as opposed to
most of the other components.
VIPdigital Manual 4.0 Yellowtec 2004 Rev. 26.07.2004 Page 50