Setting Presets; Renaming Presets; Copying Parameters Between Presets - Yellowtec Digital Voice Processor Manual

8.3.2 Setting presets

After a restart of VIPremote start-up mode is active (refer to
list is displayed (neutral names and values). Use the bar on the right side of the list to scroll through all
positions, or use the +/- buttons.
SmartCard Presets A ... C are displayed without names.
Click on a preset to exit start-up mode.

8.3.2.1 Renaming presets

The numbering or prefix (1.– 100./A ... C) cannot be changed, while the name can be edited.
To do so, activate a preset by clicking on it in the list. The text entry line above the Audio Processing
modules displays the name of this preset, and the settings stored in this preset are transferred to
VIPdigital.
Open the text entry line above the Audio Processing modules by clicking on the
by a double click with the mouse button directly on the text entry line. As a test, enter the name
"Test1" for the preset. Close the entry by pressing the Return button or click the mouse button on any
position outside the text entry fields.
All modifications made now to the parameters of the Audio Processing modules are managed under
"Test1" by VIPremote.
Exit "Test1" by activating another preset. Now, you can "give contents" to the next preset and name it
as desired.

8.3.2.2 Copying parameters between presets

The VIPremote Copy&Paste function is a very effective tool:
Use the settings of a preset as a basis for a new preset. Proceed as follows:
Activate the preset whose settings are to be copied. To do so, click on it with the left mouse button.
Now, click on the Copy
Activate the preset whose settings are to be copied and then click on the
the settings the name which can then be modified as desired was also copied.
Note 1: The Paste button will only show the
command.
Note 2: You may also access the
preset in the list and activate the right mouse button.
VIPdigital Manual 4.0 Yellowtec 2004 Rev. 26.07.2004
(Parameter) button in the upper right section.
Paste
Copy Parameters
Start-Up Mode. An "empty"
lettering if a preset was loaded before with the
and Paste Parameters
Internal Preset
Edit Name button or
Paste button. Together with
Copy
commands if you click on a
Page 54