Table of Contents
Advertisement
Safety
Safety Guidelines
The following are safety precautions that personnel must understand and follow when using or
servicing this product.
1. POTENTIAL SHOCK HAZARD - Repair procedures on PACE products should be performed
by Qualified Service Personnel only.
equipment is disassembled. Service personnel must avoid contact with these parts when
troubleshooting the product.
2. To prevent personnel injury, adhere to safety guidelines in accordance with OSHA and other
applicable safety standards.
3. Heater Cartridge Tips are hot when the handpiece is powered on and for a period of time
after power off. DO NOT touch the cartridge. Severe burns may result.
4. PACE Tip & Tool Stands and handpiece cubbies are designed specifically for use with the
associated handpiece and houses it in a manner that protects the user from accidental burns.
Always store the handpiece in its holder. Be sure to place the handpiece in its holder after
use and allow for cooling before storing.
5. Always use PACE systems in a well ventilated area. A fume extraction system such as those
available from PACE are highly recommended to help protect personnel from solder flux
fumes.
6. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the Material
Safety Data Sheet (MSDS) supplied with each chemical and adhere to all safety precautions
recommended by the manufacturer.
System Set-Up
Set up the HW 50 system using the following steps and associated images.
1. Store the shipping container in a convenient location. Reuse of these
containers will prevent damage if you store or ship your system(s).
2. Place the Power Switch in the "OFF" or "0" position.
Mounting Options
The HW 50 can be placed directly on a workbench or mounted under a workbench or shelf to
conserve space (optional mounting bracket, PN 1321-0609-P1 is sold separately). Mount the
system in this way (ST 45 shown):
1. Mount the bracket in the desired location (fasteners not supplied).
2. Insert the 2 Mounting Screws (head first) into the power source
mounting slots.
3. Place the washers over the screws.
4. Fit the power source between the bracket's support arms and
place the screws into the slots on the support arms.
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Line voltage parts may be exposed when the
Power Switch
Page 5 of 11
Hide quick links:
Advertisement
Table of Contents
