Table of Contents
Advertisement
5. Place the nut on the screw and tighten by hand.
6. Angle the power source so the operator can see the front panel easily and tighten the nuts
with a wrench or pliers.
Tip & Tool Stand
The Tip & Tool Stand can be mounted to the power source. If the system will be placed on the
workbench, this is recommended. If the HW 50 is to be mounted under the workbench or shelf, the
Tip & Tool Stand should not be mounted to the power source.
1. To attach the stand to the power source:
a) Insert the 2 large hex head Mounting Screws (head
first) into the lower "T" slot on the side of the power
source case as shown.
b) Place the Tip & Tool Stand beside the power source.
Insert ends of the 2 Mounting Screws into the 2 Tip &
Tool Stand mounting holes as shown.
c) Install a Thumb Nut onto the end of each Mounting Screw and tighten
Thumb Nuts.
d) If the Optional Instant Setback Cubby is purchased (Part Number 6019-
0071-P1), connect the Cubby connector plug into the Instant Setback
Cubby Receptacle in the following manner.
2. Place the handpiece into its Tip & Tool Stand.
Adjusting the Angle of the Cubby
The angle of the Handpiece Cubby may be adjusted by loosening the angle
thumb screw slightly, adjusting the cubby to the desired angle, and tightening the
thumb screw.
Handpiece Connection
Connect the handpiece connector plug into the Power Receptacle in the
following manner.
NOTE: Only connect the handpieces with the red connectors to
the HW 50.
1. Align guide on the connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
System Power Up
1. Insert the female end of the power cord into the AC Power Receptacle on the rear panel of
the power source.
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Instant Setback Cubby
Receptacle
Thumb Screw
Page 6 of 11
Hide quick links:
Advertisement
Table of Contents
