Installing A Usb Hypervisor Memory Key - IBM System x3620 M3 7376 Installation And User Manual

Installing a USB hypervisor memory key

Hypervisor is a virtualization platform that enables multiple operating systems to run
on a host computer at the same time. Support for hypervisor is available with the
purchase and installation of an optional USB hypervisor memory key, with
embedded hypervisor software.
To install the USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 40).
4. Locate the USB hypervisor connector on the USB connector board in the server.
5. Push down the blue locking collar on the USB hypervisor connector (the
6. Insert the hypervisor memory key into the USB hypervisor connector.
7. Pull up the blue lock on the USB hypervisor connector to the locked position, to
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 83.
Note: You must configure the server to boot from the hypervisor USB drive. See
Chapter 3, "Configuring the server," on page 89 for information about enabling the
embedded hypervisor.
82
System x3620 M3 Type 7376: Installation and User's Guide
on page 31.
external cables (see "Turning off the server" on page 19).
unlocked position).
secure the memory key in position.