IBM System x3620 M3 7376 Installation And User Manual page 92

8. Install a heat sink on the microprocessor:
76
System x3620 M3 Type 7376: Installation and User's Guide
f. Twist the handle of the installation tool counterclockwise so that it is in the
open position.
g. Align the triangle alignment mark on the microprocessor installation tool with
the triangle alignment mark on the microprocessor, then place the
microprocessor on the underside of the tool so that the tool can grasp the
microprocessor correctly onto the bottom of the installation tool.
h. Twist the handle of the installation tool clockwise to secure the
microprocessor in the tool.
Note: You can pick up or release the microprocessor by twisting the
microprocessor installation tool handle.
Handle
Installation
tool
Microprocessor
i. Carefully align the microprocessor installation tool over the microprocessor
socket. Twist the handle of the microprocessor tool counterclockwise to insert
the microprocessor into the socket.
Attention: The microprocessor fits only one way on the socket. You must
place a microprocessor straight down on the socket to avoid damaging the
pins on the socket. The pins on the socket are fragile. Any damage to the
pins may require replacing the system board.
Handle
Installation
tool
Alignment
holes
Screws
j. Carefully close the microprocessor release lever to secure the
microprocessor in the socket.
Microprocessor