Uefi Update And Configuration; Using The Lsi Logic Configuration Utility Program - IBM System x3620 M3 7376 Installation And User Manual

UEFI update and configuration

To update and configure the UEFI code to enable SOL, complete the following
steps:
1. Update the UEFI code:
2. Update the IMM firmware:
3. Configure the UEFI settings:

Using the LSI Logic Configuration Utility program

Use the information in this section to configure an optional LSI RAID controller. If
you need to configure an optional ServeRAID controller, see "Configuring a
ServeRAID controller" on page 104. You can also select System Settings and
Adapters and UEFI Drivers on the Setup utility to view a list of UEFI device
drivers that support configuration; then, select the adapter that you want to
configure to start a configuration program (see "Using the Setup utility" on page 90).
102
System x3620 M3 Type 7376: Installation and User's Guide
a. Download the latest version of the UEFI code from http://www.ibm.com/
systems/support/.
b. Update the UEFI code, following the instructions that come with the update
file that you downloaded.
a. Download the latest version of the IMM firmware from http://www.ibm.com/
systems/support/.
b. Update the IMM firmware, following the instructions that come with the
update file that you downloaded.
a. When you are prompted to start the Configuration/Setup Utility program,
restart the server and press F1.
b. Select System Settings → Devices and I/O Ports.
c. Select Console Redirection Settings; then, make sure that the values are
set as follows:
v COM Port 1: Enable
v Remote Console: Enable
v Serial Port Sharing: Enable
v Serial Port Access Mode: Dedicated COM1 Settings
v Baud Rate: 115200
v Data Bits: 8
v Parity: None Stop
v Bits: 1
v Thermal Emulation: ANSI
v Active After Boot: Enable
v Flow Control: Hardware
d. Press Esc twice to exit the Devices and I/O Ports section of the
Configuration/Setup Utility program.
e. Select Save Settings; then, press Enter.
f. Press Enter to confirm.
g. Select Exit Setup; then, press Enter.
h. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.