Installing the cover
To install the server cover, complete the following steps:
1. Make sure that all internal cables are correctly routed.
2. Align the cover over the server (toward the rear of the server) until the cover
3. Slide the cover forward toward the front of the server until the cover is
4. Tighten the thumbscrews on the rear of the cover to secure the cover to the
5. Install the server into the rack enclosure and tighten the two front thumbscrews
edges slip into position over the chassis.
Attention:
Before sliding the cover forward, make sure that all the tabs on
both the front, rear, and side of the cover engage the chassis correctly. If all the
tabs do not engage the chassis correctly, it will be hard to remove the cover
later.
completely closed.
chassis.
to secure the server in the rack.
Attention:
Two or more people are required to install the system in a rack
cabinet.
Chapter 2. Installing optional devices
85