Installing A Hot-Swap Hard Disk Drive - IBM System x3620 M3 7376 Installation And User Manual

Installing a hot-swap hard disk drive

The following notes describe the type of hard disk drives that the server supports
and other information that you must consider when you install a drive. For a list of
supported drives, see http://www.ibm.com/servers/eserver/serverproven/compat/us/.
v To confirm that the server supports the hard disk drive that you are installing, see
v Locate the documentation that comes with the hard disk drive and follow those
v The server supports up to eight 3.5-inch hot-swap SAS/SATA hard disk drives.
v All hot-swap drives in the server should have the same throughput speed rating.
The following illustration shows how to install a hot-swap hard disk drive.
Attention:
than 10 minutes without either a drive or a filler panel installed in each bay.
To install a drive in a hot-swap bay, complete the following steps:
1. Read the safety information that begins on page vii, "Installation guidelines" on
2. Remove the drive filler panel from one of the empty hot-swap bays.
3. Install the hard disk drive in the hot-swap bay:
54
System x3620 M3 Type 7376: Installation and User's Guide
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
instructions in addition to the instructions in this chapter.
For a list of supported hard disk drives, see http://www.ibm.com/servers/eserver/
serverproven/compat/us/.
Using hard disk drives with different speed ratings will cause all drives to operate
at the throughput speed of the slowest drive.
To maintain proper system cooling, do not operate the server for more
page 31, and "Handling static-sensitive devices" on page 33.
a. Orient the drive as shown in the illustration.
b. Make sure that the tray handle is open.
c. Align the drive assembly with the guide rails in the bay.
d. Gently push the drive assembly into the bay until the drive stops.
e. Push the tray handle to the closed (locked) position.
f. If the system is turned on, check the hard disk drive status LED to verify that
the hard disk drive is operating correctly.
After you install a hard disk drive, the green activity LED flashes as the disk
spins up. The amber LED turn off after about 1 minute. If the new drive starts
to rebuild, the amber LED flashes slowly and the green activity LED remains
lit during the rebuild process. If the amber LED remains lit, see the Problem
Determination and Service Guide on the IBM Documentation CD for hard
disk drive problem solutions.