Ricoh B064 Service Manual page 479

5816* Remote Service (B064 only)
001 I/F Setting
002 CE Call
003 Function Flag
004 Communication
Test Call
005 Device
Information Call
006 Device
Information Call
Display
007 SSL Disable
008 RCG Connect
Timeout
009
RCG Write to
Timeout
010 RCG Read
Timeout
SM
SERVICE PROGRAM MODE TABLES
Turns the remote diagnostics off and on.
[0~2/1]
0: Remote diagnostics off.
1: Serial (CSS or NRS) remote diagnostics on.
2: Network remote diagnostics.
Lets the customer engineer start or end the remote machine
check with CSS or NRS; to do this, push the center report
key.
Enables and disables remote diagnosis over the NRS
network.
[0~1/1]
0: Disables remote diagnosis over the network.
1: Enables remote diagnosis over the network.
Push "Execute" to do a transmission test call for NRS. The
test gives a value from 0 to 99.
[0~1/1]
0: Normal end (center operates)
1: Normal end (center does not operate)
Other: Not normal
Push "Execute" to test if the machine operates.
[0~1/1]
0: Normal end (center operates)
1: Normal end (center does not operate)
Other: Not normal
Controls if the item for initial setting of the screen for the NRS
device-information notification-call is shown.
[0~1/1]
0: Enabled. Item initial setting not shown.
1: Disable. Item for initial setting shown.
Controls if RCG (Remote Communication Gate) confirmation
is done by SSL during an RCG send for the NRS over a
network interface.
[0~1/1]
0: Yes. SSL not used.
1: No. SSL used.
Sets the length of time (seconds) for the time-out when the
RCG (Remote Communication Gate) connects during a call
via the NRS network.
[1~90/1 sec.]
Sets the length of time (seconds) for the time-out when sent
data is written to the RCG during a call over the NRS
network.
[0~100/1 sec.]
Sets the length of time (seconds) for the timeout when sent
data is written from the RCG during a call over the NRS
network.
[0~100/1 sec.]
5-77 B064 Series/B140 Series/G126