Copy Image Adjustments: Printing/Scanning; Printing; Registration - Leading Edge/Side-To-Side - Ricoh B064 Service Manual

3.14 COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING

These adjustments must be performed after replacing any of the following parts:
• Scanner wires
• Lens block
• Scanner motor
• Polygon motor
• Tandem tray side fences
• Memory All Clear

3.14.1 PRINTING

1. Make sure paper is installed correctly in each paper tray before you start these
adjustments.
2. Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for
the following procedures.
3. After completing these printing adjustments, be sure to set SP 2-902-3 to 0
again.

Registration - Leading Edge/Side-to-Side

1. Check the leading edge registration, and adjust it using SP1-001.
Specification: 3 ± 2mm.
2. Check side-to-side registration for each paper feed station, and adjust with the
following SP modes.
Tray 1 (Tandem Tray)
Tray 2 (Universal Tray)
Tray 3 (Universal Tray)
Tray 4
By-pass Tray
LCT
Duplex Tray
SM
COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING
SP mode Specification
SP1002-001
SP1002-002 0±1.5
SP1002-003
SP1002-004 Japan Only
SP1002-005
0±1.5
SP1002-006
0±1.5
SP1002-007
0±1.5
3-143
B
A
B140R887.WMF
B064 Series/B140 Series/G126