Removing The Bezel Assembly - IBM BladeCenter HS22V Installation And User Manual

Removing the bezel assembly

Use this information to remove the bezel assemble from the blade server.
The following illustration shows how to remove a bezel assembly from a blade
server.
Note:
1. The illustrations in this document might differ slightly from your hardware.
To remove the bezel assembly, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Open the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove it (see "Removing an optional
5. Carefully lay the blade server on a flat, static-protective surface.
6. Press the bezel-assembly release on each side of the blade server and pull the
7. If you are removing the bezel assembly from a blade server, disconnect the
8. Pull the bezel assembly away from the blade server.
9. If you are instructed to return the bezel assembly, follow all packaging
28
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide
Bezel assembly
release (both sides)
Control-Panel
Connector
page 19.
the blade server from the BladeCenter unit" on page 21 for instructions).
22 for instructions).
expansion unit" on page 24).
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
control-panel cable from the control-panel connector by lifting up on the
control-panel cable.
Note: Some hardware installation and removal procedures that refer to this
removal process do not require the control-panel cable to be removed. For
example, the DIMM connectors can be accessed without removing the
control-panel cable.
instructions, and use any packaging materials for shipping that are supplied to
you.
Bezel assembly
Control-Panel
Cable