Closing The Blade Server Cover - IBM BladeCenter HS22V Installation And User Manual

Hide thumbs Also See for BladeCenter HS22V:
Table of Contents

Advertisement

Closing the blade server cover

Use these instructions for information about how to close the blade server cover.
Attention: You cannot insert the blade server into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
To close the blade server cover, complete the following steps:
Cover
pins
1. Read the safety information that begins on page "Safety" on page v and
2. If you removed an expansion unit from the blade server, install it now (see
3. Lower the cover so that the slots at the rear slide down onto the pins at the
4. Pivot the cover to the closed position, as shown in the illustration, until it clicks
50
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide
Blade server
cover
Blade server
cover release
"Installation guidelines" on page 19.
"Installing an optional expansion unit" on page 23).
rear of the blade server, as shown in the illustration. Before you close the cover,
make sure that all components are installed and seated correctly and that you
have not left loose tools or parts inside the blade server.
into place.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bladecenter hs22v 7871Bladecenter hs22v 1949

Table of Contents