Completing The Installation - IBM BladeCenter HS22V Installation And User Manual

13. If you are using a single microprocessor, make sure that a memory module is
14. If you removed the bezel in a previous step, install the bezel (see "Installing
15. If you have other devices to install or remove, do so now; otherwise, go to

Completing the installation

To complete the installation, complete the following tasks.
1. Reinstall the bezel assembly, if you removed it to install other devices (see
2. Reinstall the optional expansion unit, if you removed one to install other
3. Close the blade server cover, unless you installed an optional expansion unit
4. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
5. Turn on the blade server (see "Turning on the blade server" on page 16).If you
6. For certain optional devices, you might have to run the blade server Setup
a. If you installed microprocessor 1, install the memory module into DIMM
connector 1 (see "Installing a memory module" on page 29).
b. If you installed microprocessor 2, install the memory module into DIMM
connector 10 (see "Installing a memory module" on page 29).
installed in DIMM socket 3. If two microprocessors are installed in the blade
server, make sure that memory modules are installed in DIMM socket 3 and
DIMM socket 12. See "Installing a memory module" on page 29 for more
information on installing a memory module.
the bezel assembly" on page 27).
"Completing the installation."
"Installing the bezel assembly" on page 27).
devices (see "Installing an optional expansion unit" on page 23 for information
on installing the expansion unit).
that has its own cover (see "Closing the blade server cover" on page 50).
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
server in a BladeCenter unit" on page 51).
have just connected the power cords of the BladeCenter unit to electrical
outlets, you must wait until the power-on LED on the blade server flashes
slowly before you press the power-control button.
utility to configure the blade server (see Chapter 4, "Configuring the blade
server," on page 55). See the documentation that comes with your optional
device for additional information.
Chapter 3. Installing options
49