Installing the bezel assembly
Use this information to install a bezel assembly in the blade server.
Note:
1. The following illustration shows how to install a bezel assembly in a blade
2. The illustrations in this document might differ slightly from your hardware.
To install the bezel assembly, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. If an optional expansion unit is installed, remove it (see "Removing an optional
6. Orient the bezel with the front of the blade server.
7. If the control-panel cable is not already installed, connect the control-panel
8. Carefully slide the bezel assembly onto the blade server until it clicks into
9. Install the optional expansion unit, if you removed one from the blade server
server.
Bezel assembly
release (both sides)
Control-Panel
Connector
page 19.
the blade server from the BladeCenter unit" on page 21 for instructions).
22 for instructions).
expansion unit" on page 24).
cable to the control-panel connector on the blade server.
Note: Some hardware installation and removal procedures that refer to this
installation process do not require the control-panel cable to be installed. For
example, the DIMM connectors can be accessed without removing and
reinstalling the control-panel cable.
place.
(see for instructions).
Bezel assembly
Control-Panel
Cable
Chapter 3. Installing options
27