Using The Pxe Boot Agent Utility Program; Firmware Updates; Configuring Uefi Compatible Devices - IBM BladeCenter HS22V Installation And User Manual

Using the PXE boot agent utility program

Use these instruction to start the PXE boot agent utility program.
Use the Preboot Execution Environment (PXE) boot agent utility program to select
the boot protocol and other boot options and to select a power-management
option.
Notes:
1. The blade server does not support Remote Program Load (RPL) selection for
2. Enabling PXE might reduce the number of optional expansion modules that
To start the PXE boot agent utility program, complete the following steps:
1. Turn on the server (see "Turning on the blade server" on page 16).
2. When the Broadcom NetXtreme Boot Agent vX.X.X prompt is displayed, press
3. Follow the instructions on the screen to change the settings of the selected

Firmware updates

Use this information to update the blade server to the latest levels of UEFI code
and firmware updates.
IBM periodically makes UEFI code, service processor firmware, and diagnostic
firmware updates available for the blade server and the BladeCenter unit. Before
you install the blade server in a BladeCenter unit, go to http://www.ibm.com/
systems/support/ to download the latest firmware for the BladeCenter unit and
the blade server. Install the updates, using the instructions that are included with
the downloaded files.
Important: To avoid problems and to maintain system performance, always make
sure that the UEFI code, service processor (IMM) firmware, and diagnostic
firmware levels are consistent for all blade servers within the BladeCenter unit.

Configuring UEFI compatible devices

Use this information to configure UEFI compatible devices.
Your IBM BladeCenter HS22V Type 7871 and 1949 blade server is UEFI compatible.
UEFI compatible expansion cards can be configured through the Setup utility. To
configure a UEFI compatible expansion card, complete the following steps:
Note: Before configuring a UEFI compatible device, it is recommended to update
the firmware for your blade server. See "Firmware updates" for information on
how to update the firmware for your blade server.
1. Run the Setup utility (see "Using the Setup utility" on page 56).
2. Select System Settings → Adapters and UEFI drivers.
3. Select Please refresh this page first and press Enter.
62
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide
the boot protocol option.
your blade server can manage.
Ctrl + S. You have 2 seconds (by default) to press Ctrl + S after the prompt is
displayed.
items.