Removing A Ciov-Form-Factor Expansion Card - IBM BladeCenter HS22V Installation And User Manual
Hide thumbs
Also See for BladeCenter HS22V:
- Product manual (28 pages) ,
- Supplementary manual (1 page) ,
- Supplementary manual (1 page)
Table of Contents
Advertisement
10. If you have other devices to install or remove, do so now; otherwise, go to
Removing a CIOv-form-factor expansion card
Use these instructions to remove a CIOv-form-factor expansion card from the blade
server.
The following illustration shows how to remove a vertical-combination-I/O (CIOv)
expansion card.
Expansion
card
To remove a CIOv expansion card, complete the following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. If an optional expansion unit is installed, remove the expansion unit (see
40
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide
9. Firmly press on the indicated locations to seat the expansion card.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
"Completing the installation" on page 49.
page 19.
the blade server from the BladeCenter unit" on page 21 for instructions).
22 for instructions).
"Removing an optional expansion unit" on page 24).
Advertisement
Table of Contents
