How To Start The Setup Utility; Main Setup - Supermicro Supero X9SCi-LN4 User Manual

X9SCi-LN4/X9SCi-LN4F/X9SCA/X9SCA-F User Manual

How to Start the Setup Utility

Normally, the only visible Power-On Self-Test (POST) routine is the memory test.
As the memory is being tested, press the <Delete> key to enter the main menu of
the AMI BIOS Setup Utility. From the main menu, you can access the other setup
screens. An AMI BIOS identification string is displayed at the left bottom corner of
the screen, below the copyright message.
Warning! Do not upgrade the BIOS unless your system has a BIOS-related
issue. Flashing the wrong BIOS can cause irreparable damage to the
system. In no event shall Supermicro be liable for direct, indirect, special,
incidental, or consequential damages arising from a BIOS update. If you
have to update the BIOS, do not shut down or reset the system while the
BIOS is updating. This is to avoid possible boot failure.
4-2

Main Setup

When you first enter the AMI BIOS Setup Utility, you will enter the Main setup screen.
You can always return to the Main setup screen by selecting the Main tab on the
top of the screen. The Main BIOS Setup screen is shown below.
Main Advanced Event Logs
System Overview
System Time [09:20:40]
System Date [Tue 06/14/2010]
Supermicro X9XXX-X
Version 1.0
Build Date 11/18/2010
Processor
Intel(R) Core(TM) i5-2500 CPU@ 3.3GHz
Speed 1600MHz
Physical Count 1
Logical Count 4
System Memory
Size 2048MB
BIOS SETUP UTILTY
IPMI Boot Security
Version x.xx.xxxx. Copyright (C) 2010 American Megatrends, Inc.
Exit
4-2
Set the time. Use tab
to switch between Time
elements.
 : Select Screen
 : Select Item
Enter: Select
+/- : Change Opt.
F1 : General Help
F2 : Previous Values
F3 : Optimized Defaults
F4 : Save & Exit
ESC : Exit