Supermicro Supero X9SCi-LN4 User Manual page 104

X9SCi-LN4/X9SCi-LN4F/X9SCA/X9SCA-F
a USB CD/DVD ROM/RW device can be used for this purpose. However, a USB
Hard Disk drive cannot be used for BIOS recovery at this time.
To perform UEFI BIOS recovery using a USB-attached device, follow the instruc-
tions below.
1. Using a different machine, copy the "Super.ROM" binary image file into the
disc Root "\" Directory of a USB device or a writeable CD/DVD.
Note: If you cannot locate the "Super.ROM" file in your driver disk, visit our
website at www.supermicro.com to download the BIOS image into a USB
flash device and rename it to "Super ROM" for BIOS recovery use.
2. Insert the USB device that contains the new BIOS image ("Super.Rom") into
your USB drive and power on the system
3. While powering on the system, keep pressing <Ctrl> and <Home> simultane-
ously on your PS2 or USB keyboard until your hear two short beeps. This
may take from a few seconds to one minute.
4. After locating the new BIOS binary image, the system will enter the BIOS
Recovery page as shown below.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main Advanced
WARNING! BIOS Recovery Mode has been detected
Flash Update Parameters
Reset NVRAM
� Proceed with Flash Update
Version 2.12.1211. Copyright (C) 2011 American Megatrends, Inc.
Note: At this point, you may decide if you want to start with BIOS Recov-
ery. If you decide to proceed with BIOS Recovery, follow the procedures
below.
Event Logs IPMI Boot Security
[Enabled]
C-2
Exit
Recovery
Set this to start ash
update
�� : Select Screen
�� : Select Item
Enter: Select
+/- : Change Opt.
F1 : General Help
F2 : Previous Values
F3 : Optimized Defaults
F4 : Save & Exit
ESC : Exit