Usb Wake-Up (Jpusb1); Bmc Enable (Jpb) - Supermicro Supero X9SCi-LN4 User Manual

USB Wake-Up (JPUSB1)

Use the jumper JPUSB1 to "wake-up" your
system by pressing a key on a USB keyboard
or clicking the USB mouse connected to the
Backplane USB Ports 0/1. JPUSB1 is used
together with a USB Wake-Up feature in the
BIOS. Enable this jumper and the USB sup-
port in the BIOS to wake up your system via
USB devices.
Note: When the USB is set to Enabled in
the BIOS, and JPUSB1 is set to Disabled,
remove the USB devices from Backplane
USB Ports 0/1 before the system goes
into the standby mode.

BMC Enable (JPB)

JPB is used to enable or disable the BMC
(Baseboard Management Control) chip and
the onboard IPMI connection. This jumper is
used together with the IPMI settings in the
BIOS. See the table on the right for jumper
settings.
B
JPUSB1 (Backplane USB
Pin#
1-2
2-3
BMC IPMI Enable/Disable
Settings
Pins 1-2
Pins 2-3
2-35
Chapter 2: Installation
0/1 Wake-up Enable)
Definition
Enabled (Default)
Disabled
Jumper Settings
Definition
Enabled (Default)
Disabled
A. USB 0/1 Wake-up
B. BMC Enable
A