Loading Supply For Non-Peel Mode - Avery Dennison Monarch 9416 XL Equipment Manual

L o a d i n g S u p p l y f o r N o n - P e e l M o d e
This section describes how to load supplies in the printer to print in non-peel
(continuous) mode. Make sure the black mark/die cut sensor is set correctly for your
supply type. See "Adjusting the Black Mark/Die Cut
Note: If you run out of supply while printing, do not turn off the printer when
reloading the supply. You may lose your data. The printer resumes printing
when reloaded.
Remove and discard the tape from a new roll of supply. Unwrap and discard
1.
supply with any glue residue.
Press the release levers (located on both sides of the printer) towards the front of
2.
the printer to release the supply door.
Lift open the supply door. The supply door support at the right-hand rear of the
3.
printer holds the supply door open.
3-2 Equipment Manual
Sensor," for more information.
Supply Door
Support