Lantronix SecureLinx User Manual page 41

To set the IP address:
1. At the command prompt, type set ipaddress, followed by the IP address and
press Enter.
Example
The following command sets the IP address to 12.34.56.78:
Setting the subnet mask
The Set Subnet command sets the subnet mask for the network in which the unit will
be attached.
To set the subnet mask:
1. At the command prompt, type set subnet, followed by the subnet mask and
press Enter.
Example
The following command sets the subnet mask to 255.0.0.0
Setting the gateway
The Set Gateway command sets the IP address of the default gateway the unit uses
to access external networks.
To set the gateway IP address:
1. At the command prompt, type set gateway, followed by the gateway IP
address and press Enter.
Example
The following command sets the gateway IP address to 12.34.56.1:
Displaying network configuration information
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL and SNMP
configuration information.
IP address, subnet mask and gateway
Enabled-disabled status of Telnet, SSH, HTTP,SSL and SNMP support
Telnet, SSH, and HTTP port numbers
HTTP authentication method and SSL access setting
Network status
See
4:Advanced Operations
SecureLinx SLP Remote Power Manager
SLP: set ipaddress 12.34.56.78<Enter>
SLP: set subnet 255.0.0.0<Enter>
SLP: set gateway 12.34.56.1<Enter>
for more information on SNMP
3: Operations
41