Lantronix SecureLinx User Manual page 18

Creating a descriptive outlet name:
1. Click on the Outlet Names link which will open the Outlets configuration page.
See
names.
Creating a descriptive serial port name:
1. Click on the Serial Port Names link which will open the Serial Port configuration
page. See
descriptive serial port names.
Network
The Network configuration page is used for maintenance of the network interface.
From this page an administrator may configure the IP address, subnet mask and
gateway address as well as view the link status, speed and duplex value.
The following network defaults allow unit configuration out-of-the-box through either
Telnet/SSH or web browser:
IP address:
Subnet Mask:
Gateway:
The initial local PC network connection must be configured as Noted below:
Note: Contact your system administrator for instructions in reconfiguring the
network connection. Reconfiguration of your network connection may
require a restart to take effect.
IP address:
Subnet Mask:
Note: The unit must be restarted after network configuration changes. See
Performing a warm boot
Setting the IP address, subnet mask or gateway:
1. In the appropriate field, enter the IP address, subnet mask or gateway address
and press Apply.
Telnet/SSH
The Telnet/SSH configuration page is used to enable or disable Telnet and SSH
support and configure the port number that the Telnet or SSH server watches. For
more information on SSH see
Enabling or disabling Telnet or SSH support:
1. Select Enabled or Disabled from the appropriate Server drop-down menu and
press Apply.
Changing the Telnet or SSH server port number:
1. In the appropriate Port field, enter the port number and press Apply.
Note: The default ports numbers are: port 23 for Telnet, and port 22 for SSH.
SecureLinx SLP Remote Power Manager
on page 20 for additional information on creating descriptive outlet
Outlets
on page
Serial Port
192.168.1.254
255.255.255.0
192.168.1.1
192.168.1.x (where x is 2-253)
255.255.255.0
on page 40.
Advanced Operations
19 for additional information on creating
on page 47.
3: Operations
18