Lantronix SecureLinx User Manual page 39

To display system configuration information:
1. At the command prompt, type show system and press Enter.
Example
Creating a descriptive unit name
The Set Unit Name command assigns a descriptive name to a unit. This descriptive
name is displayed when the Show Traps command is issued. See
configuration information
command.
To create a unit name:
1. At the command prompt, type set unit name, followed by the absolute unit
name, then the descriptive name of up to 24 alphanumeric and other typeable
characters (ASCII 33 to 126 decimal - spaces are not allowed).
2. Press Enter.
Examples
The following command adds the descriptive name Florida_HQ_1 to unit.a:
Displaying unit information
The Show Units command displays information about the unit. This information
includes the absolute and descriptive unit names.
To display unit information:
1. At the command prompt, type show units and press Enter.
Example
Creating a descriptive infeed name
The Set Infeed Name command assigns a descriptive name to an infeed. This
descriptive name is displayed when the Show Traps command is issued. See
Displaying trap configuration information
Show Traps command.
SecureLinx SLP Remote Power Manager
System Information
F/W Version: SecureLinx Power Manager Version x.xx
NIC S/N: 1600001
MAC Address: 00-80-a3-8b-00-0e
H/W Rev Code: 0
Flash Size: 1 MB
Uptime: 0 days 6 hours 14 minutes 1 second
Location: Florida HQ
on page
SLP: set unit name .a Florida_HQ_1<Enter>
SLP: show units<Enter>
Unit Unit
ID Name
.A Florida_HQ_1
55 for more information on the Show Traps
on page 55 for more information on the
3: Operations
Displaying trap
39