Lantronix SecureLinx User Manual page 23

SNTP
The SNTP configuration page is used for setup and maintenance of SNTP support.
Setting the SNTP Server Address:
1. Enter the IP address in the primary and/or secondary address field and press
Apply.
SNMP
The SNMP configuration page is used for setup and maintenance of all settings
required to enable SNMP support as well as access to the trap configuration pages.
For additional information on SNMP support and detailed descriptions of available
traps, see
Note: Traps are generated according to a hierarchical architecture; i.e. if a
Tower (Unit) Status enters a trap condition, only the Tower Status trap is
generated. Infeed and Outlet Status traps are suppressed until the Tower
Status returns to Normal.
Enabling or disabling SNMP support:
1. Select Enabled or Disabled from the drop-down menu and press Apply.
Setting the community strings:
1. Enter the community string in the appropriate field and press Apply.
Community strings may be 1 to 24 characters
Setting the trap timer:
1. Enter a trap timer value in the Error Trap Repeat Time field and press Apply.
The Error Trap Repeat Time value may be 1 to 65535 (in seconds).
Setting trap destinations:
1. Enter an IP address in the appropriate Trap Destination field and press Apply.
Enabling or disabling tower (unit) traps:
1. Click on the Tower Traps link.
2. On the subsequent page, select or deselect the desired traps and press Apply.
Configuring input feed traps:
1. Click on the Input Feed Traps link.
2. On the subsequent Input Feed Traps page, select or deselect the desired traps
and press Apply.
3. For Load traps, enter a maximum load value for the infeed in the High Load
Threshold field and press Apply.
The High Load Threshold value may be 0 to 255 (in amperes).
Configuring outlet traps:
1. Click on the Outlet Traps link.
SecureLinx SLP Remote Power Manager
on page 49.
SNMP
3: Operations
23