Lantronix SecureLinx User Manual page 38

To set the serial port data rate:
1. At the command prompt, type set port speed all, followed by the data rate
and press Enter.
Example
The following command sets the serial port data rate to 38400 BPS:
System Administration
Creating a location description
The Set Location command specifies text that appears in the web browser control
screen's Location field. The text is also appended to a "Welcome to" banner that
appears when a user successfully logs in serially or through a Telnet session.
If you do not issue this command, or if you issue this command without specifying
any text, the control screen's Location field will be blank and no Welcome to banner
will be displayed.
To create a location description:
1. At the command prompt, type set location, followed by a descriptive name of
up to 24 alphanumeric and other typeable characters (ASCII 32 to 126 decimal -
spaces are allowed). Press Enter.
Omitting any characters after typing set location deletes any previously
specified text.
Examples
The following command specifies Florida HQ as the descriptive location for the
control screen and the login banner:
The following command deletes any previously specified location description:
In this case, the control screen's Location field will be blank, and no Welcome banner
will be displayed after a successful login.
Displaying system configuration information
The Show System command displays all system configuration information.
Firmware version
NIC module serial number and MAC address
Hardware revision code and Flash size
Uptime since last system restart
System location description
See
4:Advanced Operations
SecureLinx SLP Remote Power Manager
SLP: set port speed all 38400<Enter>
SLP: set location Florida HQ<Enter>
SLP: set location<Enter>
for more information on SNMP.
3: Operations
38