Command Set; Lan Specific Commands; Read The Hostname; Read The Ip Address - TDK-Lambda Z+ series User Manual

For the complete command set, please refer to Z

10.1 Lan Specific Commands

10.1.1 Read the Hostname

The hostname may be read with this query
Syntax:
Example:
Response:

10.1.2 Read the IP Address

The IP address may be read with this query
Syntax:
Example:
Response:

10.1.3 Read the MAC Address

The MAC address may be read with this query
Syntax:
Example:
Response:

10.1.4 Reset the LAN Settings

Sending this command could disable the LAN connection to the power supply. It may be required
to reset the power supply.
This command will reset the LAN settings to the factory default state. The effect of this command
includes changing the IP address and hostname, so LAN communication could be lost. Therefore,
only use this command as a diagnostic tool.
Syntax:
Example:

10.1.5 Blinking the Identity LED

Syntax:
Example:

10 COMMAND SET

SYSTem:COMMunicate:LAN:HOST?
SYST:COMM:LAN:HOST?
The hostname string,up to 16 characters long
Example: Z10-40-123 is a typical default hostname
SYSTem:COMMunicate:LAN:IP?
SYST:COMM:LAN:IP?
The IP address string, up to 15 characters long
Example: 169.254.9.35 is a typical default IP address
SYSTem:COMMunicate:LAN:MAC?
SYST:COMM:LAN:MAC?
The MAC address string, 17 characters long
Example: 00:19:f9:00:24:3b is a typical default Mac address
SYSTem:COMMunicate:LAN:RESet
SYST:COMM:LAN:RES
SYSTem:COMMunicate:LAN:IDLED 1 / ON,0 / OFF
SYSTem:COMMunicate:LAN:IDLED 1
+ Instruction Manual.
WARNING:
28