Table of Contents
Advertisement
2.
Mounting the Optional AAP Device
Various Extron RGB 580xi AAP double-space devices may be
mounted to any Extron product that has an AAP faceplate, or to
an Extron AAP wallplate. See
numbers. The AAP device should be cabled before it is attached
to a faceplate or wallplate (see
Connectors"
an AAP device are built into its front panel, so no additional
screws are needed.
1.
Cable
Clamp
Example of mounting an AAP device to a wallplate
2.
Peaking control — The Video Output Peaking control
affects the sharpness of a picture. Increased peaking can
compensate for detail (mid- and high-frequency) loss from
low bandwidth system components or capacitance in long
cables. The minimum setting (at the counterclockwise
limit) provides no peaking. The maximum setting (at
the clockwise limit) provides 100% peaking. Adjust this
control while viewing the displayed image to obtain the
optimum picture sharpness.
in this chapter). The screws needed for installing
Insert the AAP's screws through the holes in the AAP
faceplate or the AAP wallplate. Secure the AAP device
to the faceplate or wallplate with the provided captive
washers and #4-40 nuts.
#4-40 Nut w/ Captive
Washer
3
Follow steps
through
section of this chapter.
RGB 580xi • Installation and Setup
appendix A
for AAP device part
"Cabling the AAP Device Rear
AAP 102
Cable
0 2
P 1
A A
C O
U T
IN P
C T
L E
S E
T
H IF
H S
RGB 580xi SI AAP
in the
"Installation Overview"
8
D IO
A U
E R
U T
M P
A P
I A
i S
0 x
5 8
B
R G
2-11
Advertisement
Table of Contents
