Extron electronics RGB 580xi User Manual page 22

Control One-Piece Captive Screw Conn 2.eps
Installation and Setup, cont'd
RGB 580 xi AAP control wiring
Horizontal shift ground (gray)
Contact closure
Contact closure
2
LED connector (J2) — Insert wires into and tighten the screws
on the 3.5 mm, 3-pole captive screw connector. This connector
is used for powering the green and amber LEDs. Wire the
connector as shown in the following illustration.
RGB 580 xi AAP LED 2-piece wiring
3 Audio output connector (J3) — Insert wires into and tighten
the screws on the 3.5 mm, 3-pole captive screw connector. This
connector is used for unbalanced stereo audio output. Wire the
RGB 580xi AAP audio output wiring
connector as shown in the following illustration.
RGB 580xi • Installation and Setup
2-14
+
Horizontal shift (green)
–
Horizontal shift (brown)
+
(light blue)
–
(purple)
Green LED (pink)
LED ground (yellow)
Amber LED (orange)
Audio Two-Piece Captive Screw Conn2.eps
Unbalanced Output
Audio left (white)
Audio ground (black)
Audio right (red)