Cabling The Aap Device Rear Connectors - Extron electronics RGB 580xi User Manual

Input select button — Pressing this button results in contact
5
closure between pins A and B of the contact closure control
connector on the front panel of the RGB 580xi.

Cabling the AAP Device Rear Connectors

Various Extron AAP devices for the RGB 580xi may come with
several rear connectors that require cabling.
To cable the captive screw connectors, refer to the following
diagrams and orient the wires according to the view angle of
the captive screws. When using the Extron VGA and control
cable assembly (see appendix A,
Replacement Cables"
each wire for signal identification.
Example of AAP device rear connectors
Example of AAP device rear connectors
1
Control connector (J4) — Insert wires into and tighten the
screws on the 3.5 mm, 5-pole captive screw connector. This
connector is used for contact closure and horizontal shifting
signals. Wire the connector as shown in the following
illustration.
Although the VGA and control cable/LED assembly
comes prewired to the captive screw connectors, any
subsequent cable assembly replacement will require the
following cabling instructions.
for part numbers), refer to the color of
SHIFT
SELECT
3
Red
Black
Green
Yellow
White
Gray
Pink
Brown
Orange
RGB 580xi • Installation and Setup
"Optional RGB 580xi AAP
AUDIO IN
COMPUTER IN
RGB 580xi
Lt. Blue
Purple
1
2
2-13