Table of Contents
Advertisement
HORIZONTAL
SHIFT
Control One-Piece Captive Screw Conn 2.eps
1
Control connector (J4) — Insert wires into and tighten the
screws on the 3.5 mm, 5-pole captive screw connector. This
connector is used for contact closure and horizontal shifting
signals. Wire the connector as shown in the following
illustration.
RGB 580 xi AAP control wiring
Horizontal shift
Horizontal shift ground (gray)
Horizontal shift
Contact closure
Contact closure
2
LED connector (J2) — Insert wires into and tighten the screws
on the 3.5 mm, 3-pole captive screw connector. This connector
is used for powering the green and amber LEDs. Wire the
connector as shown in the following illustration.
RGB 580 xi AAP LED 2-piece wiring
LED ground (yellow)
Amber LED (orange)
Troubleshooting
Turn on the input devices (computer, audio device) and output
device(s) (projector, monitors, speakers). The image should now
appear on the screen, and sound should be audible.
INPUT
SELECT
RGB 580xi CCSI AAP
+
(green)
–
(brown)
+
(light blue)
–
(purple)
Green LED (pink)
The VGA and audio cable assemblies are routed through
the Cable Cubby. Refer to the Cable Cubby User's
Manual (part #68-701-01) for Cable Cubby installation
instructions.
RGB 580xi • Installation and Setup
2
1
2-17
Advertisement
Table of Contents
