Extron electronics RGB 580xi User Manual page 15

Universal remote interface with audio and adsp
Hide thumbs Also See for RGB 580xi:
Table of Contents

Advertisement

Contact closure control connector — Connect an optional
4
contact closure device to this female 5-pole captive screw
connector. Making contact closure between pins A and B
transmits a channel signal through the RS-232 port. Extron
RGB 580xi I AAP and RGB 580xi SI/CCSI AAP (see
Device Features"
this chapter) provide a one-button contact closure operation.
Wire the male connector as shown below on the left. Extron
VGA and control cable assembly (see chapter A,
5-pin Contact Closure Captive Screw Con_lateral.eps
580xi AAP Replacement
connector prewired as shown at right.
Contact closure
Contact closure
Ground
RGB580xi contact closure pinout table.eps
Contact closure wiring
Pin
A
B
C
D
E
N
Video output: level control — This control adjusts picture
5
brightness by compensating for signal amplitude loss caused by
cable resistance. See
Video output: peaking control — This control adjusts picture
6
sharpness by compensating for cable capacitance caused by long
cable runs. See
DIP switches — This bank of DIP
7
switches controls DDSP (Digital Display
Sync Processing), serration pulse output,
SOG (sync on green) output, vertical sync
width, sync polarity, and composite sync output. Moving a
switch up sets it to On and moving it down sets it to Off.
and
Contact Closure
5VDC
5VDC
Contact closure
Contact closure +
Contact closure -
+5V
Gnd
-5V
The contact closure pins on the RGB 580xi's front panel
are not to be used for horizontal shift control. See the
horizontal shift control wiring in the 15-pin HD pin out
c
table in
"Front Panel Adjustments"
"Front Panel Adjustments"
The default for all DIP switches is Off (down).
RGB 580xi • Installation and Setup
"Cable Cubby AAP Device Features"
Cables") comes with the male control
Male VGA connector
Prewired male control
cable connector
Description
Contact closure + circuit
Contact closure - circuit
+5V source for powering AAP devices
Signal ground for powering AAP devices
-5V source for powering AAP devices
on the previous page.
"AAP
"Optional RGB
Prewired male control connector
in this chapter.
in this chapter.
SOG
V-SYNC WIDTH
SERR
NEG SYNC
DDSP
COMP SYNC
in
2-7

Advertisement

Table of Contents
loading

Table of Contents