Cabling The Cable Cubby Aap Devices - Extron electronics RGB 580xi User Manual

Installation and Setup, cont'd
1 Power/signal LED — This LED lights
•
•
2 Horizontal shift control knob — While viewing the displayed
image, rotate this control to move the image to the right or left
on the screen. The power/signal LED flashes green whenever
the minimum and maximum limits of this control are reached.
3
Input select button — Pressing this button results in contact
closure between pins A and B of the contact closure control
connector on the front panel of the RGB 580xi.

Cabling the Cable Cubby AAP Devices

Extron's various CC AAP devices for the RGB 580xi come with
rear panel connectors that may require cabling.
To cable the captive screw connectors, refer to the following
diagrams and orient the wires according to the view angle of the
captive screws.
RGB 580xi • Installation and Setup
2-16
amber to indicate that the CC AAP device is receiving
power.
green to indicate that an active sync signal is present at the
input and that the CC AAP device is receiving power.
The LED flashes green whenever the minimum and
maximum limits of the horizontal shift control (H. shift)
have been reached.
DDSP disables the horizontal shifting control.
Although the control cable/LED cable assembly comes
prewired to the captive screw connectors, any subsequent
connector replacement will require the following cabling
instructions.