Table of Contents
Advertisement
Installation and Setup
Installation Overview
C
To install and set up an RGB 580xi, follow these steps:
1
2
3
4
5
6
7
8
RGB 580xi • Installation
2-2
Installation and service must be performed by
authorized personnel only.
Turn all of the equipment off. Make sure that the
computer, the RGB 580xi, and the output devices
(projector/monitor, speakers) are all turned off and
disconnected from the power source.
For under-desk mounting:
A.
Determine the installation location: table, desk,
podium, or other suitable location. If Architectural
Adapter Plates are to be connected to the interface,
consider where they will be located in relation to
the interface. See
chapter.
B.
Mount the interface. See
mounting"
Attach output cables to the rear panel of the interface
and to the output devices. See
Cabling"
in this chapter.
Attach input cables to the input devices and to the
interface's front panel connectors. See
Features and Cabling"
Set the front panel DIP switches. Use the
Features and Cabling"
Connect power cords and turn on the output devices
(projector/monitor, speakers). Next, power up the
remote interface, and then the audio and video input
devices.
The picture should appear, and sound should be audible.
If not, ensure that all devices are plugged in and receiving
power. Check the cabling and make adjustments as
needed.
While watching the display, adjust the video level and
peaking by using the rotary Level and Peaking controls.
See
"Front Panel Adjustments"
"Application Diagrams"
"Under-furniture
in this chapter.
"Rear Panel Features and
in this chapter.
section of this chapter as a guide.
in this chapter.
in this
"Front Panel
"Front Panel
Advertisement
Table of Contents
