Set Home State Parameters; Figure 3-50 Target Dpc Address Prompt - Comtech EF Data Vipersat CDD-562L User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-50
Target DPC Address prompt
The STDMA Burst Controller (Demod 1 on a CDD-56X configured as Hub
with No Expansion) is not permitted to specify a DPC Target because the
demodulator is receiving multiple bursts very rapidly from all Remotes in the
group and is unable to utilize DPC to control the transmit power of the Remote
modems.

Set Home State Parameters

A CDD-56X's Home State consists of those parameters which provide a
known RF configuration that the CDD-56X will return to, either as the result of
a command by the VMS, or as it comes back on line from a reset or a power
cycle.
Enter H at the command prompt in the Vipersat Configuration screen to
display the Home State Configuration screen shown in figure 3-51.
Figure 3-51
Home State Configuration screen
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e
3-40