Slot Start In Cycle; Set Remotes; Adding A Remote To The Stdma Group; Figure 3-19 Stdma Remotes Menu Screen - Comtech EF Data Vipersat CDD-562L User Manual

V i p e r s a t C o n f i g u r a t io n

Slot Start in Cycle

This menu item appears in the STDMA screen when the Unit Role is Remote;
however, it is not relevant since a Remote configuration does not enable
STDMA.

Set Remotes

This menu item appears in the STDMA screen when the Unit Role is Hub with
No Expansion.
Entering an R at the command prompt displays the STDMA Remotes Menu as
shown in figure 3-19. This screen is used to define and make modifications to
the Remotes that belong to the STDMA group for the Hub burst controller, as
well as to display the burst map status information for each Remote.
Figure 3-19
STDMA Remotes Menu screen

Adding a Remote to the STDMA Group

Entering the item number for the Remote demodulator/router brings up the
dialog shown in figure 3-20. A prompt to enter the Name to assign to the
Remote unit appears, followed by a prompt to enter the IP Address for this unit.
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-19