Vipersat Feature Codes; Figure 3-4 Feature And Unlock Code Dialog - Comtech EF Data Vipersat CDD-562L User Manual

Use this screen to enable and disable Vipersat features such as:
• Vipersat STDMA — Burst mode operation
• Vipersat Auto Switching — Allows switching to SCPC mode
• Vipersat File Streamer — Rapid file transfers over satellite network
Note: These Vipersat features must be Enabled or Disabled using this menu.
NOTE

Vipersat Feature Codes

From the Feature Configuration menu, verify whether or not the Vipersat
Feature Codes appear as shown in figure 3-3. These codes are entered prior to
shipment from CVNI; however, if the unit has been reset to factory default, the
codes will have to be re-entered. If the Feature codes are not displayed in the
menu, enter F at the command prompt.
The Vipersat Feature Codes can be entered as three hexidecimal digits at the
command prompt as shown in figure 3-4.
Each Feature code must have a corresponding Unlock code that determines
whether that feature has been purchased and is available for use on the target
CDD-56X.
Tip: Contact either the network administrator or Comtech Vipersat Networks
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 -
They are not accessible from the Vipersat Configuration menu.
Figure 3-4
Customer Support to obtain the Feature and Unlock codes. A convenient
option is to use the Vipersat Vload utility to manage Feature and Unlock
codes.
Feature and Unlock Code dialog
M e n u D e s c r i p t i o n s
3-5